Tools needed for fitting graphics:

1) Methylated spirit, pure alcohol or a good glass cleaner.
2) Water spray bottle full of water with a drop of washing-up liquid mixed in. (only needed for larger graphics or sun strips)
3) Cloth
4) Masking tape
5) Ruler or tape measure
6) Plastic squeegee or credit card
7) Scalpel, craft knife or stanley knife

1) Make sure area for application is clean and dry and if possible give it a wipe over with some meths or alcohol.

2) Measure out and tape the graphic in the exact position you want it to be making sure the graphic is taped in the middle and both ends.

3) Leaving the graphic taped in the middle tare off one end of the masking tape leaving half on the vehicle and half on the graphic and peel the graphic off of the backing paper and cut the backing paper away being careful not to cut vehicle.

4) Carefully place the graphic back in its original position by lining the two torn bits of masking tape back together.

5) Now with a squeegee or credit card, squeegee in and up and down motion from the middle of the graphic outwards.

6) Then remove the masking tape holding the middle and repeat the same steps with the other side of the graphic.

8) If there are any bubbles left under the graphics burst them by making a small hole with a knife or pin at one side of the bubble and push the air out from the other side.

© Boss Dog
34 Radstock Way, Merstham, Surrey. RH1 3NG - Office 01737 643720 - Mobile 07843 563956
Email sales@bossdog.co.uk